Make your own free website on Tripod.com


Handyman
Replacing A baby shower Pump   


plumber
Shower pump is a good device to have around in the event you constantly face difficulties with the pressure of water supply feeding into your shower head. To change an existing setup, you only need to follow the instructions in the pump manual. Alternatively, a plumber or handyman will improve able to complete the replacement process while he or she shall have adequate information in terms of this device. The steps mentioned below is likely to make replacing a shower pump easy.


plumber
Firstly, verify that the pump you've got purchased is of the pressure setting since your previous one. Pressure is measured in bars of course, if your old pump is rated at 1.5 bars then it is precisely what the new pump also needs to deliver. Next, remove electricity supply for the old pump and disconnect the wires to isolate these devices. After that, cut off water supply for the old pump and disconnect the inlet and outlet pipes keeping a note of which pipes go where. You are ready to start setting up the new pump.

When you're getting the new pump placed in place, notice if you have any alteration needed to the existing pipe work. In that case then you can make use of the pipes given the new pump to give or decrease the pipe lengths. As soon as your pipes are ready, connect the inlet pipe and outlet pipe for the pump’s appropriate openings employing a rubber washer and gauze filter. Tighten it to ensure there are no leakages. Finally, rewire the pump in much the same as it was with all the old pump and activate the electric supply for the new pump. Your pump is currently ready to be used for an additional shower.